Holds bags of many sizes with adjustable height. Can be mounted in many ways. 

How to assemble - How to use: The product can be used in either of the three ways shown below.

When using the door hook:

The hooks can be connected by attaching the upper part of each hanger into the groove of another hook. (The same method is used to connect each hook no matter how the top is used)

When using the hanger hook:

When hanging the item in a closet, the hangers can be attached in opposite directions as well, as photo.

When using the wood screw (wall):

Only one hook has a hole on the top for the screw.

● For doors from 2.7 to 3.6cm deep with a free space of at least 3mm above the door. 

● Door / folding door: required gap between door and upper part: 3 mm or more.
* This product is intended for general indoor flat doors.
* Do not use it on a glass door.

● Pillar / Outer wall / Printed plywood (where there is a horizontal horizontal bar on the back side)
* Do not use on fragile walls such as gypsum board, plaster, mortar, thin plate walls of 5 mm or less, hard walls such as concrete, blocks and bricks, tiles and joints of tiles.

● Maximum Weight Capacity 2.2 lbs (1.1kg) / hanger (Be sure to follow this restriction)